Sears 625.34823 Care of Your Filter, Helpful Hints CHECKLIST...TO Help YOU Save Money

I SECTION 6 I CARE OF YOUR FILTER

BEFORE YOU CALL FOR SERVICE

I

HELPFUL HINTS CHECKLIST...TO HELP YOU SAVE MONEY

By making a few easy checks, you can often avoid an unneeded service call. If your water filter fails to work, check these things. If, after making the checks it still does not work right, call your Sears Service Department.

FILTER WILL NOT BACKWASH (Water contains sediments, iron, dirt, sand, etc.)

_-]MANUAL BYPASS VALVE(S) IN BYPASS POSITION - See FIG. 11, page 13. Move stem

in single bypass valve to SERVICE. In a 3-valve bypass, open the inlet and outlet valves, close the bypass valve.

_'_ TRANSFORMER UNPLUGGED AT THE

WALL OUTLET, OR POWER CABLE

DISCONNECTED - Check for loss of power and correct. Reset the times, then use the RECHARGE

NOW feature (See page 16).

r_ FUSE BLOWN, CIRCUIT BREAKER POP-

PED, OR CIRCUIT SWITCHED OFF - Replace fuse, reset circuit breaker, or switch circuit on.

Reset times and use the RECHARGE NOW feature.

NOTE: SEE "TIMER POWER-OUTAGE MEMORY," PAGE 17.

HOUSE WATER PRESSURE LOW

I_ WELL PUMP PRESSURE SET TOO LOW - Adjust to a MINIMUM of 20 psi.

I'_ BACKWASH NEEDED MORE OFTEN TO KEEP FIL1;ER MINERAL BED CLEAN - Set

the timer for more recharges (See pages 15 and 16).

[]

r-_

TIMER IN THE VACATION (VAC) POSITION - Press the VACATION button once to return

the filter to service (page 16).

TIMER NOT PROGRAMMED FOR RECHARGES - See pages 15 and 16 to select

and program a schedule. Use the RECHARGE

NOW feature.

[] VALVE DRAIN HOSE PLUGGED - Hose must not have kinks, sharp bends, or any water flow

blockage. (See page 12.)

18.