Replacement and Care
c. Install new tilters in the tilter hous- ing track with the glue beads of the wicking pad to the inside of the filter housing.
d. Return the top cover of the filter housing by installing the cover over the fixed tabs on the rear of the lower tilter housing and pivoting the cover down over the top of the fil- ters. Snap the cover over the two spring tabs.
e. Replace the tilter housing in the cabinet. Note: There is a left and a
right tilter housing. There is also a front and back orientation. To posi- tion the filter housings correctly:
•Make sure the two indents in the cylinder section of the top covers are positioned towards the center of the cabinet.
•Be sure that the spring tabs of fil-
ter housings are towards front of cabinet.
•Align the lower portion of the filter assembly over the six ribs located at the bottom rear of the humidi- tier cabinet.
fo Position fan assembly onto the cab- inet. Make sure the fan venturi (low- est cylinder section below the fan) is placed inside the tilter housing.
g. Replace water bottles.
h. Close the pivoting lid on the fan assembly.
i. The unit is ready for use or to be "stored away for next season.
NOTE: For correct operation of the filter housing assembly, tilters n_ust be fully contained inside the flange of the top cover.
of Filters (continued)
Fixed
Tabs
Spring
Tabs
Filter
Rear of
Front of
Humidifier
| Indents | |
Top | Towards Center | |
Cabinet | ||
Cover | ||
|
Flat Portion of Filter Housing
Towards Back of Cabinet
Indents Toward Center
of Cabinet
Step 4.e.
1o