Using Your Humidifier

Step 1

Be sure unit is full of water and plugged

in.

Step 2

Set the Fan selection switch to "2". This will allow both fans to operate if the humi- distat senses humidity is needed.

Step 3

Set speed control to low.

Step 4

Set Humidity Control to medium position. NOTE: Humidifier should operate with humidity control on the recommended MEDIUM setting. If it does not, the humidity is at a relatively high level. To test the unit under this condition, turn Humidity Control all the way to MAX and unit should begin to operate. After unit has been tested, set Humidity Control to MEDIUM or desired level.

Allow 24 hours for humidifier to adjust.

If humidity level in home is sufficient, the humidifier will only operate with Humidity Control set on maximum.

IMPORTANT: Water damage may result if condensation starts to form on windows or walls. Humidity Control setting should

be lowered until condensation no longer forms.

Step 5

If humidifier stops running, the humidity level is at the normal requirements for that setting or it is adjusting to the home condi- tions. The table below shows approximate relative humidity percentages which cor- respond to the various settings of the Humidity Control.

		Recommended
When	Outdoor	Indoor Relative
Temperature is:		Humidity is:
-10°F		20%
	0°F	25%
	10°F	30%
20°F	& above	35%

HUMIDITY

MIN

MAX

Operating Tips for Best Performance

1.Position the humidifier at least 2 inches

from-a_y_vall and away from any heat registers.

2.Do not restrict airflow from entering or exiting the humidifier.

3.Use Sears recommended bacteriostat

42-14900 to retard bacteria growth that may cause odors and may be harmful to your health.

4.Regular cleaning as instructed in "Cleaning of Humidifier" section of this manual is recommended.

5.Replacement of the evaporative wicking filter at least once per humidification season or more depending on water conditions in your area.