Troubleshooting

Unit will not shut off.

Unit will not dry out completely

I Bottles continue to empty.

Probable Cause

•Humidity level is too high

•No power

•Float is not free

•Water is present in the system

•High humidity or low temperature resulting in slow evaporation

•Air is entering water reser- voirs.

Remedy

• Raise humidistat setting

• Check 120 volt power source

• Free float from obstruction

• This is normal. A small

the cabinet.

• Allow unit to continue opera-

tion.

• Check "E-Z-Fill Side-Caps" to

ensure tightness.

• Check for leak in water bottles.

• Are gaskets for "E-Z-Fill Side-

Caps" in place (see repair

parts list).

Unit is not emptying. • Dirty filter

•Reservoir cap plunger missing post in bottom of cabinet.

Unit runs and shuts off before bottles are empty

!• Humidity level is too high

•Unit is not setup on a level surface (Float will not sense water at the rear of the cabinet.

• Raise humidistat setting (if

possible)

• Position unit level (Some car-

pet padding may allow unit to

set lower in the front than the

rear with the additional weight

of water bottles in the front of

the cabinet. Install coasters

under front casters.

CAUTION: Use only 42-14900EPA Registered Bactedostat available from

Sears Retail store.

Use of other water treatment products may damage the filter elements.

Under no circumstances should you use water treatment products designed for Roto belt or Ultrasonic humidifiers.