![](/images/new-backgrounds/1057734/5773483x1.webp)
SECTION 2
.ow YOUR WATER SOFTENER WORKS
II
2A.FACE PLATE TIMER FEATURES
EXTRA RECHARGE
Sometimes, a manually started regeneration (re-
charge) may be desired, or needed. Two examples
aye:
--You did not refill the softener with salt before it was gone.
You can start a regeneration fight away, or you can
set the timer to regenerate at the next 2:00 AM (or
other preset recharge time). Do the following.
PROGRAM MEMORY
If electrical power to the softener goes off, the time display is blank but the face plate timer keeps the
correct time for about 6 hours. When electrical power comes on again, you have to reset the present time only if the display is flashing. The HARDNESS
and RECHARGE TIME never require resetting unless a change is desired.
Even if the timer is incorrect after a long power
outage, the softener works as it should to keep you
water soft. However, regenerations may occur at the wrong time of clay until you reset the timer to the correct time of day.
RECHARGE NOW
•Press the
button | and | bold | • | for :_seconds. | 3" | ! "_ | M | |||
RECHARGE |
|
| _ |
| to |
| I_p | |||
NOW | begins | RECHARGENOW | ||||||||
flash | in the | display, | and | the |
|
|
| |||
softener | enters the | fill | cycle | of regeneration | right | |||||
away. | This | regeneration |
| will | last for | about | 2 | |||
hours. | Then, | you |
|
| will | have | soft | water again. |
|
ERROR CODE
An error code could appear in the face plate display
if a problem occurs in the softener electronics. If you see an error code instead of the time of clay, please
call you local Sears Service Department for service.
RECHARGE TONIGHT
• Press and release (do not
hold) the
ton. RECHARGE TONIGHT RECHARGETONIGHT
flashes in the display, and the
softener begins regeneration at the next preset
recharge time. If you decide to cancel the regen- eration before it has started, press and release the
IF YOU NEED HELP ON THE USE OF THE TIMER FEATURES, CALL TOLL FREE, NUMBER
10