Sears 625.34842 owner manual SET Water Hardness Number, SET Recharge Regeneration Time

lC.PROGRAM

2. SET WATER HARDNESS NUMBER:

•Press the SELECT button once to display 15 (flashing) and HARDNESS.

The grains per gallon (gpg) hard- ness of your water supply is on

NOTE:

If your water supply contains iron, compensate for it

by adding to the water hardness number. For

examp& assume .you; water is 15 gpg hard and

contains 2 ppm iron. Add 5 to the hardness number

._)r each 1/)/)m of iron. In this example, you would

use 25 _)r your hardness number.

15 gpg hardness

2 ppm iron x 5 = 10 +10

(times) 25 HARDNESS NUMBER

•Press the {_ UP/DOWN {_] buttons to set your

water hardness number in the display. The DOWN button moves the display to 1. The UP button moves

the display to the highest setting (see maximum setting for your model in the specifications).

NOTE:

Each press of the UP/DOWN button changes the display by 1 between ] and 25. Between 25 and the highest number, the display changes 5 at a time... 25, 30, 35, etc. Continuous pressure on the UP or DOWN button changes the display twice each second.

THE TIMER

3. SET RECHARGE (REGENERATION) TIME:

• Press the SELECT button once to display 2:00 AM

(flashing) and RECHARGE TIME.

At the 2:00 AM RECHARGE TIME setting, the softener begins regen- eration (see pages 11 and 12) at 2:00 AM, ending no later than 4:00 AM. This is a good time in most

households because water is not being used (see AUTOMATIC BY- PASS, page 13).

If a different RECHARGE TIME setting would be

better for your household, do the following.

•Press the {_ UP/DOWN{_ buttons to set the desired RECHARGE starting hour. Be sure to observe the AM-PM as you did when setting the time of clay.

NOTE:

Each press of the UP/DOWN buttons changes the

display 1 hour. Continuous pressure on the UP or

DOWN button changes the display twice each second.

•Press the SELECT button once again, to return the present time (steady) of clay and RECHARGE TONIGHT in the display.

I

RECHARGE TONIGHT,J