uu/au/vu | uu;_o | "/,3"o_ 4_b UI41 | 3_AH_ | L_]01O |
Selecting a Relative Humidity Setting:
All of the settings on your dehumidifier are electronically
controlled.
50% maintains a 50% Relative Humidity level
60% maintains a 60% Relative Humidity level
70% maintains a 70% Relative Humidity level
80% maintains a 80% Relative Humidity level "CONTINUOUS" will dehumidify
To select a Relative Humidity setting, (Continuous, 50% 60%, 70%, B0%)
1.Depress the "DRY" keypad until the required setting is selected. Each depression of the keypad will change the relative humidity setting, identified by the illuminated window adjacent to your selection made. (If existing relative humidity conditions in your room register "lower" than the relative humidity level selected, No dehumidifying will take place (fleshing
..green window), The fan will operate but the compressor wilt remain in an oft cycle, until the relative humidity level is lowered accordingly (below RH level
of room),
Selecting a Fan Speed Mode:
1.To select a fan speed, each depression of the "Fan" keypad will alternate between the "High" & "Low" fan speed settings, identified by the illuminated window adjacent to your selection.
Heat mode:
The Heat mode provides a featUre that will allow you the option to setting temperatures in either "Celsius" or
"Farenheight".
NOTE: This must be accomplished before you
It is not possible to aCcess existing ambient room conditions during HEAT mode,
Follow these steps:
t, Depress the MODE keypad to select either DR'i or FAN, Identified by the illuminated window adjacent to the selection,
2.Depress the (_) keypad, allowing you to alternate between the "CPF RH settings adjacent to the
LED display
3, When the window adjacent to the "C illuminates, the LED will display temperatures in "Celsius".
4.When the window adjacent to the "F illuminates, the LED will display temperatures in
"Farenheight". The illuminated RH window automatically defaults to the "C (Celsius) scale
HEAT MODE:
To select nHeat", depress the "mode" key pad. Each depression of the key pad will alternate through each of the optiona! modes. (DRY, HEAT, FAN) When the window adjacent to the "Heat" mode illuminates, the selection Is complete.
Temperature;
To select]adjust "temperature" depress either of the
/_) key pads.
The _ keypad increases temperature settings. (as outlined below)
The _ keypad decreases temperature settings. (as outlined below)
(Celsius scala 1" increments) Adjustable temperature range
(Fatenheight scala 2" increments) Adjustable temperature range
The temperature appearing in the LED display ia the temperature at which heater will cycle.
Both heater and fan will stop, when the ambient room temperature reaches the set temperature, displayed in th* LED window
Fan Speed,
Each depression of the "Fan" keypad will alternate between the "High" & "Low" fan speed s_ttlngs,
identified by the illuminated window adjacent to your selection.
•High Fan: will produce 1150 watts of Heating output
•Low Fan will produce 950 watts of Heating output
10