S P E A K E R S E L E C T I O N S Y S T E M
3.Make the connections to the SPS-4. Strip 3/8" of insulation from the end of each wire. Tightly twist the end of each wire until there are no frayed ends. Insert each wire into the appropriate hole on the spring-loaded connector terminals. Be certain that proper phasing is observed — connect the positive terminals on the SPS-4 to the positive terminals on the amplifier and speakers and the negative terminals on the SPS-4 to the negative terminals on the amplifier and speak- ers. See (Figure 3).
4.Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area over each ON/OFF selector button.
Figure 3
Connecting the
Wires