Hunter Fan 42710-01 operation manual Connecting the Wires

Page 17

installing the thermostat, cont.

CONNECTING THE WIRES

1. Loosen, but do not remove, the terminal screws.

	Jumper	Note: A jumper wire has been provided, connecting the
		Note: A jumper wire has been provided, connecting the
		RC and RH terminals for systems that do not provide both
G RC RH Y W		an RH and RC wire. If you have both an RH and RC wire,
		remove this jumper. If you do not have both an RH and RC
		wire, leave the jumper in place.

2.Match and connect the wires from the wall to the terminals as shown. Wires should be inserted behind the black terminal shields. Tighten each screw after the connection has

been made.

(The ends of any extra wires should be individually wrapped in electrical tape and carefully pushed back into the wall.)

3.Push any excess wire length back into the wall to prevent interference.

17

Image 17

Contents Set & $ave Page Table of Contents Set & Save Important information Tools Page Page Uninstalling the existing unit RC / VC Wire labelsUninstalling the existing unit, Page Installing the Wall Plate Installing the thermostatPage Installing the thermostat, RC W/B Connecting the Wires Thermostat Cover System Switch Fan Attaching the Thermostat Front cover Tab Installing the thermostat, Reset Settings Day/time SETTINGS, Heat Methods of operation Heat Manual Operation / Override Methods of operationSystem Off Heat Cool Permanent Override Tod Home Today Override Set Temp Vacation Override Default Programs Chart Default Programs System Heat Program Off Cool Creating Custom Programs System Heat Off Cool Program Hold Return Methods of operation Filter Icons and Features Energy Icons and FEATURES, Reset Icons and FEATURES, Stage Icons and FEATURES, Hold Return Icons and FEATURES, Page Icons and FEATURES, Program Range Important featuresTroubleshooting Page Troubleshooting Is there help on the web? Can’t I just call someone?