Heath Zenith 6270 manual Tune Settings, 3 4 5, All models

Tune Settings

Your Heath®/Zenith wireless chime has different selectable tunes: Ding (one note), Ding-Dong(two note), or Westminster (eight note) (Available on se- lected Heath®/Zenith chimes). The factory setting is for the Ding-Dong tune (or Westminster, when available). This tune can be changed by following the instructions below.

•Ding (one note tune)

Push Button: Add a jumper to location 8.

•Ding-Dong(two note tune)

Push Button: Remove jumper from location 8.

Chime: Remove jumper from location 8.

•Westminster (Eight note tune) (Available on selected Heath®/Zenith chimes)

Push Button: Remove jumper from location 8.

Chime: Add a jumper to location 8.

Note: All models have both front and back door tune capabilities. You may purchase any Heath®/Zenith wireless push button for a second entrance. We recommend the back door use the Ding tune and the front door use the Ding- Dong tune (or Westminster tune, available on selected Heath®/Zenith chimes). Models that include two push buttons will come factory set for front and back doors. Decals on the rear of the push button will indicate its setting.

Inside Chime

ry

Push Button Battery Replacement

Install an alkaline type A23 12Volt battery.

See diagram inside push button for correct battery orientation.

mihC

e

V

o

l

ume

1 2 3 4 5 678

B	Tune Setting
ery	(Not used on
	all models)

1 2 3 4 5 678

Inside Push

Button

*Code Settings 1-7 Must Match Both Push Button and Chime

Tune Setting

Note: Some models might require the use of tweezers to remove and replace the jumpers.

- - 595-5506-11