3Com TECHD-0000000050 manual Zpha Installation, Blank Faceplate Segment Module

The following image displays the Blank Faceplate Segment Module.

Figure 2 - 5: Blank Faceplate Segment Module

The following image displays USB ports located on the ZPHA back panel.

Figure 2 - 6: USB Ports Back Panel

ZPHA Installation

When you install the ZPHA, you need the following components:

•USB cable — 1 cable for connecting to the IPS to receive power (included with device). The modular ZPHA provides 2 USB ports (1 type A and 1 type B) on the back panel.

•RJ-45 copper network cables — 4 per segment (cables not included)

•LC-LC Simplex Multi-mode Fiber cable — 4 per segment (included with device). You should have 4 cables currently with your IPS device to connect to the ZPHA.

Note: For Simplex Single-mode Fiber cables, contact a TippingPoint Sales

Representative.

UnityOne Modular Fiber/Copper ZPHA Installation Guide V 2.1

9