LG Electronics HB8004RA4, L8004RY4, HB8004RB4 Refrigerating Cycle, Evaporator, Capillary Tube

Disassembly

RefrigeratingCycle

12. Condenser

CAUTION: Discharge the refrigerant system using a FreonTM Recovery

System. If there is no valve to attach the recovery system, install one (such as a WATCO A-1) before venting the FreonTM. Leave the valve in place after servicing the system.

1. Remove the cabinet. (Refer to section 2)

2. Remove the 4 screws that fasten the brace.(Refer to section 4)

3. Remove the 5 screws that fasten the condenser and shroud.

4. After discharging the refrigerant completely, unbraze the interconnecting tube at the con- denser connections.

5. Remove the condenser.

6. Re-install the components by referring to notes.
(See Figure 23)	Figure 23

13. Evaporator

1. Remove the control box.(Refer to section 3)

2. Remove the air guide upper. (Refer to section 4)

3. Remove the 2 screws that fasten the evapora- tor.

4. Move the evaporator sideways carefully. (Refer to section 4)

5. After discharging the refrigerant completely, unbraze the interconnecting tube at the evapo- rator connections.

6. Remove the evaporator.	Figure 24
7. Re-install the components by referring to notes.
(See Figure 24)

14. Capillary Tube

1.Remove the cabinet. (Refer to section s2)

2.After discharging the refrigerant completely, unbraze the interconnecting tube at the capillary tube.(See caution above)

3.Remove the capillary tube.

4.Re-install the components by referring to notes.

Service Manual 17