LG Electronics PRCKD40E, PRCKD20E owner manual Action Start Time, Front

Page 21

Reservation function of wired remote controller

7 Press up, down button to adjust the Minute on Start Time section.

8 Press right button to move to 'Hour' Part on OFF Time section.

(The 'Hour' segment will be flashed)

Off Time Section

9 Please refer the process from No.5 to No.7 for setting OFF Time. It is same method.

10 If you finish the setting, press setting/cancel button to complete programming.

The under bar segment will be created, when it finished.

11 Please refer the process from No.2 to No.10 for setting other day weekly program. It is same method.

12 Press exit button to exit or system will automatically release without any input after 25 seconds.

ENGLISH

<Note>

 

 

 

Description of

weekly reservation

 

 

<Start Time Section>

<Off Time Section>

 

Action

 

To

 

Start Time

 

Off Time

 

Front

 

 

 

Two actions per weekday can be programmed, in total 14 actions

 

 

 

Owner's Manual

21

Image 21
Contents AHU Control KIT Table of Contents Meanings of symbols used in this manual are as shown below Safety PrecautionsIt can cause a fire or problem to the product It can cause a fire or an electric shockIf not, it can cause a fire or an electric shock InjuredIt can cause an explosion or a fire You can get injured by doing so It can cause vibration or leakageNecessary sensor by operating mode Part Description Name and Function of Remote ControllerBasic operation of wired remote controller Main function of wired remote controller Current humidity / CO2 level Humidifier Supplementary function of wired remote controllerDesired humidity control Auto ventilaton Desired CO2 Level control Default humidity is set to 1000ppmChanging Current Time Setting AM / PM value byAHU Control KIT Programming Setting Simple Reservation Segment flashing Ex Setting Simple Reservation time asPress button to finish setting Programming Setting on Reservation Programming Setting OFF Reservation Programming Weekly Reservation Front Action Start TimeRelease a selected day as Programming Holiday ReservationHow to start installation setting mode Setting function by code Central control address setting 1Enter the Installation Setting mode Damper opening settingFlashes Press the Right button to move to ‘Setting of 1’ Cooling mode ‘01’ OA /‘02’ EA / ‘03’ MixingEnglish Remote control Master/Slave setting Remote controller Manual operating modeSA fan operation RA fan operationCheck before requesting for service Test run Once you resolve the error, the error code will disappearSelf diagnosis function Detail descriptionError Remote controller to the AHU controllerSensor value is in the error range Indoor unitSituation Example of errorAHU Control KIT No. MFL62171702