Sears 139.53859 owner manual Own,as,oliows, Model Function Remote Control, Side

Owner's Manual

Model 139.53879

3-Function Remote Control

To comply with FCC rules, adjustment or moditicalions o! 1his receiver end!or transmitter are prohibited except for changing the code seltlng or replacing the

battery THERE ARE NO OTHER USER SERVICEABLE PARTS

Model 139.53859

Compact 3-Function Remote Control

The 53000 Series remote control works only with door openers and light controls having a green "SRT" button and green indicator light.

Instructions are given below for programming your

opener to match the remote control's code. The additional remote control buttons can also activate

other garage door openers and/or light controls. (Instructions for programming light products are included with those accessories.)

operating or playing with a garage door

opener can injure themselves or others. The

garage door could close and cause serious Injury or death. Do not allow children to operate the

door push button(s) or remote control(s).

A moving garage door could Injure or kill someone under It. Activate the opener only when

you can see the door clearly, it is free of obstructions, and Is properly adjusted.

......I_L i, i,I ' in

Program the Opener to Accept the Remote Control Code

Select a remote control push button to operate the receiver The large button is recommended for use with the garage door opener.

1 Press and HOLD the selected remote control push button, Figure 1_

2.Then press and release the green "SRT" button on the right side panel of the opener in Figure 2oThe opener light wit flash once.

3 Retease the remote control push button

Now the opener wilt operate when the remote control push button is pressed

If you release the remote control push button before the opener light flashes, the opener has not accepted the code.

To Change the Selected Push Button

On the Same Remote Control

If you decide to use a different remote control button than originally programmed into the opener, you need to erase aflthe learned codes and reprogram each remote control used to operate the garage door opener

To Erase All Remote Control Codes

. Press and hold the green "SRT" button on the opener panel until the indicator light turns off (about 6

seconds). All the codes the opener has learned will be erased.

-To reprogram, repeat Steps I - 3 for each remote control in use,

Code programming instructions are also located on the opener panel.

3_Function remote control housing only (no circuit board) - 4 IA4873;

Compact remote controlReplacementhousing only (noParts:circuit board) - 4 IA4874; ] 3V 2016 Lithium Battery - 10A!9 (2 required); Visor Clip - 29£I 34

L

FIGURE 1 select e remote control push

button 1ooperate opener

3-Function	Compact	3-Function
Remote Control	Remote	Control

53000 Series Garage Door Openers

(With Green "SRT" Button and Green Indicator Light)

Green "SRT"

Button

Green Indicator

Ught

	The Remote	Control	Batteries
The lithium batteries should			j._-,,,..3-FUNCTtON
produce	power for up to 5 years.._,,'_-._res_				'toh'_ve;dd
Replace	batteries positive	side		_-,_,-_.._:z_	cracking
.own,as,oliows
3-Function remote.: Use the C-_L_				Twlst _&')
visor clip	or screwdriver	_,_		",--_., toop_r,
		COMPACT

blade to pry open the case

as shown To repIace the cover, insert the 3 tabs at the opposite end and snap shut

Compact remote Use a screwdriver b!ade to pry open the case as shown To replace cover, snap shut along both sides

	© 1995, Sears Roebuck & Company
114A 1959	All Rights Reserved	Pnnled in Mexico