G. Cleanup and joint movement
Remove all excess cement from around the pipe and fitting with a dry cotton rag. This must be done while the cement is still soft.
The joint should not be disturbed immediately after the cementing procedure, and sufficient time should be allowed for proper curing of the joint. Exact drying time is difficult to predict because it depends on variables such as temperature, humidity and cement integrity. For more specific information, you should contact your solvent cement manufacturer.
OPERATION
WARNING
NEVER OPERATE THE HEATER WITHOUT FIRST BEING
CERTAIN IT IS FILLED WITH WATER AND A TEMPERATURE
AND PRESSURE RELIEF VALVE IS INSTALLED IN THE RELIEF
STEP GVALVE OPENING OF THE HEATER. DO NOT ATTEMPT TO OPERATE HEATER WITH COLD WATER INLET VALVE CLOSED.
T & P VALVE and PIPE INSULATION | TO OPERATE THE WATER HEATER |
Remove insulation for T & P Valve and pipe connections from carton.
Fit pipe insulation over the
Fit T & P valve insulation over valve. Make sure that the insulation does not interfere with the lever of the T & P valve.
Secure all insulation using tape.
FILLING
1.Close the heater drain valve by turning handle clockwise Fig. 1 (T)
2.Open a nearby hot water faucet to permit the air in the system to escape.
3.Fully open the cold water inlet pipe valve (allowing the heater and piping to be filled. Fig. 1(M)
4.Close the hot water faucet as water starts to flow from the faucet.
5.The heater is ready to be operated.
12