Graco 223596, 239140 important safety instructions Skin Injection Hazard

Page 3

WARNING

SKIN INJECTION HAZARD

Spray from the gun, hose leaks, or ruptured components can inject fluid into your body and cause extremely serious injury, including the need for amputation. Fluid splashed in the eyes or on the skin can also cause serious injury.

DFluid injected into the skin might look like just a cut, but it is a serious injury. Get immediate surgical treatment.

DDo not point the gun at anyone or at any part of the body.

DDo not put your hand or fingers over the spray tip.

DDo not stop or deflect leaks with your hand, body, glove or rag.

DDo not “blow back” fluid; this is not an air spray system.

DAlways have the tip guard and the trigger guard on the gun when spraying.

DCheck the gun diffuser operation weekly. Refer to the gun manual.

DBe sure the gun trigger safety operates before spraying.

DLock the gun trigger safety when you stop spraying.

DFollow the Pressure Relief Procedure on page 8 whenever you: are instructed to relieve pres- sure; stop spraying; clean, check, or service the equipment; and install or clean the spray tip.

DTighten all fluid connections before operating the equipment.

DCheck the hoses, tubes, and couplings daily. Replace worn, damaged, or loose parts immediately. Permanently coupled hoses cannot be repaired; replace the entire hose.

DUse only Graco approved hoses. Do not remove any spring guard that is used to help protect the hose from rupture caused by kinks or bends near the couplings.

MOVING PARTS HAZARD

Moving parts, such as the air motor piston, can pinch or amputate your fingers.

DKeep clear of all moving parts when starting or operating the pump.

DBefore servicing the equipment, follow the Pressure Relief Procedure on page 8 to prevent the equipment from starting unexpectedly.

307619 3

Page 2 Page 4
Image 3
Page 2 Page 4
Contents Part No , Series a 461 Ratio Presidentr Pump Instructions-Parts ListImportant Safety Instructions Part No , Series B 231 Ratio Monarkr PumpTable of Contents Skin Injection Hazard Fire and Explosion Hazard Installation Prepare the Operator Prepare the SiteGrounding KEY Typical InstallationSystem Accessories Flush the Pump Before First Use Pressure Relief ProcedureStarting and Adjusting the Pump OperationShutdown and Care of the Pump Flushing the PumpExplosion Hazard on Problem Cause Solution TroubleshootingService Disconnecting the Displacement PumpReconnecting the Displacement Pump Displacement Pump Service DisassemblingReassembling Detail B Piston Packings Detail a Throat PackingsParts Model 223596, Series B Ratio CST Monarkr Pump shownModel 237958, Series B Ratio SST Monarkr Pump Packing NUT/WET-CUP, CST Model 223595, Series DIncludes items 3, 4, 5, 6, 10, 12, Model 239140, Series a Ratio SST Presidentr PumpPacking NUT/WET-CUP Model 239145, Series aConversion Kits Ptfe Conversion KitPTFE/Leather Conversion Kit Model 223596 shown Dimensions Mounting HoleModel Dimension 223596 237958 239140 LayoutTechnical Data Sound Power Levels dBaInput Air Pressures at 15 cycles per minute Model 223596 231 Ratio CST Monark Performance Chart Model 237958 231 Ratio SST Monark Performance ChartMonark 231 Fluid Outlet Pressure Monark 231 Air Consumption Page Models 239140 461 Ratio SST President Performance Chart Graco Information Graco Standard Warranty
Top Page Image Contents