Belkin ST6125D, ST4125D manual ST-4125D/ST-6125D -TROUBLESHOOTING, Pump Troubleshooting

Page 23

ST-4125D/ST-6125D TROUBLESHOOTING

Practically all breakdowns can be prevented by proper handling and maintenance inspections, but in the event of a breakdown, use Table 6 (Pump Troubleshooting) as a basic guideline for troubleshooting the pump. If the problem cannot be remedied, contact Multiquip's service department.

TABLE 6. PUMP TROUBLESHOOTING

SYMPTOM

POSSIBLE PROBLEM

SOLUTION

 

 

 

 

 

Check that proper voltage (230/460 3Ø) is being supplied to the pump.

 

Incorrect voltage/amps?

Also check that there is an adequate amount of current (amps) to run

 

 

the pump. Check power source circuit breaker.

 

 

 

 

Check electrical connections?

If using float switches check wiring, inspect power cord.

 

 

 

 

Blown power fuse?

Replace fuse, check cause of blown fuse.

Pump Fails To Start

 

 

Impeller locked?

Disconnect power cord and check for clogging and improper impeller

 

clearance. Unclog pump. Check overload protection device.

 

 

 

 

 

 

 

Use multimeter to check motor insulation. Insulation resistance must

 

Wet motor windings?

be approximately 15 megaohms. If resistance is low, disassemble

 

 

pump motor and bake windings to dry them.

 

 

 

 

Defective motor and pump

Check for excessive bearing wear, if worn replace bearings. Replace

 

bearings?

motor if defective.

 

 

 

 

Twisted or restricted discharge

Lay hose flat un-kinked. Remove clog from hose line.

 

hose?

 

 

 

 

 

Clogged pump strainer?

Clean strainer.

Pump Fails to Deliver

 

 

 

Use a voltmeter to check voltage while pump is energized. Voltage

Full Output

 

Low voltage?

must be within ±10%. Check power source (no load and load). If an

 

 

extension cord is used, make sure it has adequate current-carrying

 

 

 

 

capacity for the required length.

 

 

 

 

Impeller worn?

Replace impeller.

 

 

 

Water in Seal Oil

Defective water seal?

Replace water seal.

 

 

Loose Oil Fill Plug?

Tighten securely.

 

 

 

 

ST-4125D/ST-6125D SUBMERSIBLE PUMPS — OPERATION AND PARTS MANUAL — REV. #1 (06/12/08) — PAGE 23

Image 23
Contents Submersible Pumps Model ST4125D Model ST6125D ST-4125D/ST-6125D Table of Contents Order via Fax Dealers Only Parts Ordering ProceduresBest Deal! Order via Internet Dealers Only Page Foryour Safety and the Safety of Others ST-4125D/ST-6125D Safety Message Alert SymbolsST-4125D/ST-6125D Rules for Safe Operation General SafetyEmergencies Maintenance SafetyST-4125D/ST-6125D Rules for Safe Operation ST-4125D/ST-6125D Dimensions Specifications ST-4125D/ST-6125D SpecificationsST-4125D/ST-6125D General Information ST-6125D ST-4125D/ST-6125D Submersible Pump ComponentsFloat Switch Theory ST-4125D/ST-6125D Float SwitchesThermal ST-4125D/ST-6125D Control BoxesPhase Power Installation Input ST-4125D/ST-6125D Control BOX Installation230/460VACVoltage Selection ST-4125D/ST-6125D 230/460 VAC Voltage SelectionControl Box Wiring Diagram ST-4125D/ST-6125D Control Boxwiring DiagramPersonnel ST-4125D/ST-6125D 3-PHASE Power InstallationThree Phase Control Box/Pump System Diagram ST-4125D/ST-6125D 3-PHASE Power InstallationManual-Off-Auto SW. Manual Position ResetOperation ST-4125D/ST-6125D OperationST-4125D/ST-6125D Operation Pump Shut-Down/Clean-upST-4125D/ST-6125D Maintenance Pump Troubleshooting ST-4125D/ST-6125D -TROUBLESHOOTINGPump Performance Curves ST-4125D/ST-6125D Performance CurvesPage QTY. Column Explanation of Code in Remarks ColumnNO. Column Part NO. ColumnSubmersible Pump 1 to 3 Units ST-4125D/ST-6125D Suggested Spare PartsST-4125D Submersible Pump Assy Remarks ST-4125D Submersible Pump AssyST-6125D Submersible Pump Assy ST-6125D Submersible Pump AssyCABLE, POWER, 24 MM ST-6125D Submersible Pump Assy Thermal Sensor Freight Policy Terms and Conditions of Sale PartsPage HERE’S HOW to GET Help

ST6125D, ST4125D specifications

Belkin is renowned for producing high-quality networking and connectivity solutions, and their ST4125D and ST6125D models exemplify this commitment. The ST4125D is a 4-port USB hub, while the ST6125D serves as a versatile 6-port USB hub, both designed to enhance productivity and connectivity for users, especially in environments where multiple devices are used simultaneously.

One of the main features of the Belkin ST4125D and ST6125D is their ability to expand USB connectivity effortlessly. Each hub allows users to connect multiple devices to a single USB port, which is particularly useful for laptops and desktops that have limited ports. The ST4125D features four USB 3.0 ports, while the ST6125D includes six, making them perfect for connecting printers, external hard drives, and other peripherals without having to switch devices.

Another significant technology integrated into both models is USB 3.0, which offers data transfer speeds of up to 5 Gbps. This high-speed performance not only ensures rapid file transfers but also improves efficiency when moving large volumes of data. The backward compatibility with USB 2.0 devices also ensures that users can connect older peripherals without any issues, making these hubs highly versatile.

The design of the ST4125D and ST6125D hubs promotes convenience and ease of use. Their compact and lightweight form factor makes them portable, ideal for both home and office environments. Additionally, the hubs feature individual power switches for each port, granting users control over power management and enhancing energy efficiency.

Furthermore, both models boast an LED indicator for power status, providing real-time feedback to users. They also come equipped with a sturdy build quality, ensuring longevity and durability even with regular use. With plug-and-play functionality, setting up the hubs is hassle-free, requiring no additional drivers or software installation.

In conclusion, both the Belkin ST4125D and ST6125D USB hubs present excellent solutions for anyone seeking enhanced connectivity options. With their combination of speed, functionality, and user-friendly features, they are a valuable asset in today’s increasingly device-driven world. Whether for personal use, home offices, or larger business settings, these hubs stand out as reliable tools that meet diverse connectivity needs effectively.