Winding a Bobbin

x Place spool of thread onto spool pin. x Press spool holder ring against spool.

CAUTION: Spool of thread should be rotated freely after pressing the holder ring on.

x Lead thread to Guidepost (1) and draw to the left under pretension stud (2).

x Draw thread between the two tension discs of thread tension dial, then pull thread to right as shown.

x Follow arrows. Guide thread through guidepost (3).

x Open the bobbin winder cover and in- sert a bobbin.

x Align the small bobbin hole on pin of bobbin winder.

x Follow arrows. Manually wind thread clockwise around the bobbin 3-5 turns, then pass thread through the notch.

x Still holding end of thread, push on/off switch and start to wind

x Trim the end of the thread after bobbin is wound around a few times. (5-10 winds)

x Continue to wind bobbin until desired amount is reached and cut thread.

CAUTION: Do not over-wind bobbin. Over-winding causes thread jamming of bobbin case.