Top Innovations SP-403 owner manual Threading the Machine

Page 9
Pull thread to Guidepost (1) and draw it to left, under pretension stud (2).
Draw thread between two tension discs and then pull to right as shown.

THREADING THE MACHINE

x Place spool of thread onto spool pin. x Press spool holder ring against spool.

CAUTION: Spool of thread should be ro- tated freely after pressing the holder ring on.

x

x

x Follow arrows, guide thread into take-up lever eyelet (3) and then backwards to wire loop (4).

x Top view of threading.

x Slip thread through (5).

x Insert needle threader through needle eye and pull thread through needle eye.

x Pull thread 2-3 inches to the front.

8

Image 9
Contents Innovative Products to Make Your Life Easier Page Contents Parts Listing Accessories Parts Listing cont’dWinding a Bobbin Inserting the Threaded Bobbin Case Threading the BobbinRemoving Bobbin & Bobbin Case Threading the Machine Raising the Bobbin Thread Balanced stitch Adjusting Thread TensionStart to SEW-HANDHELD Operation Start to SEW-TABLE-TOP Operation Start to SEW-HANDHELD Operation Darning Securing a SeamHOW to Replace the Slide Plate Turning a Square CornerChanging Needles If stitch is not formed Performance ChecklistTurning a Square Corner Limited Warranty Page