3-2. Setting Telescopic Thread Stand
Extend the telescopic thread stand to its full height, then turn it until the shaft clicks into its locked
position.
3-3. Changing Threads
The machine is supplied with thread but
iiiy I au•.y
(1) Cut the thread in use near the cone spool (behind the telescopic thread stand). Place the new thread on the spindle and tie it to the end
of the original thread.
(2) Raise the presser foot lifter to lift up the presser foot.
(3)Press down the tension release lever so that the thread knot can pass through smoothly, draw out the looper thread until the thread knot comes to about 10 cm past the presser foot.
(4)When changing the needle thread, cut off the thread knot before it reaches the eye of the needle to avoid bending the needle as the knot is pulled and caught in the needle’s eye.