13. | REPLACING LOWER CUTTER |
|
Replacing Lower Cutter | F | |
* Unplug the machine |
| |
(1) | Open front cover and disengage upper cutter. |
|
(‘See page 3) |
| |
(2) | Loosen lower cutter clamp screw®and remove | a |
| lower cutter. |
|
(3)Set the new lower cutter.
Align the top of lower cutter with the top of needle plate, and tighten lower cutter clamp screw a
14. CHANGING LIGHT BULB
When the light does not come on even though it is switched on:
How to remove the lamp cover.
(1)Take out the power supply plug.
(2)Remove the presser foot lifter by pulling it out.
(3)Remove the lamp cover.
(4)Change the light bulb.
(5)Replace the lamp cover.
How to use the bulb catcher (plastic sheath),
(1)Take out the power supply plug.
(2)Place the bulb catcher (plastic sheath) found in the accessory box around the bulb in the direction of arrow , turn it in the direction of arrow ©, and remove the bulb.
(3)Replace the new bulb in the reverse steps
of (2).
15. LUBRICATION
Although Lubrication is not required often for this machine since the important parts are all made of a special oil impregnated sintered metal, one or two