Sears 385.17724 owner manual To Remove the Bobbin from the Machine Wind the Bobbin

Page 18

'

o To Remove the Bobbin from the Machine	o Wind the Bobbin
f

1.Gently push down on the bobbin cover plate and slide _t towards you.

2.Set astde.

3.Lift out the bobbin, as shown.

NOTE: The bobbin winder stopper can be adjusted for

the amount of thread needed on the bobbin

(example 1/ 2 full or full etc.). To make the

adjustment use your large screw driver and loosen the screw one turn or tess, This will allow

you to adjust the position of bobbin winder stopper. Do not take screw all the wayout.

Ctu[ch

1.Put your spool of thread onto spool pin, with the thread winding in the direction sh own.

2.Putl the clutch away from the machine to stop the needle from moving while you winding the bobbin.

3.Draw thread from spool through bobbin winder tension disc as shown.

4.Place the threaded bobbin on the bobbin winding spindle so that the thread comes out on top,

5.Push the bobbin winder spindle to the right until it clicks.

6.Holding onto end of thread, depress the foot control.

7.When the bobbin is slightly fiIled, stop the machine and clip the thread coming from the bobbtn.

8.Slowly start the machine again and wind the thread until the bobbin stops.

9.Push the bobbin winder spindie to the }eft and clip the thread,

10, Remove the bobbin.

11.Push in the clutch for normal sewing operation.

15

Image 18

Contents Sewing Machine Important Safety nNSTRUCTIONS IntoKenmore Sewing Machine Table of Contents Ro taroleGasegr,CabmettsAva=lableiJ BaseFoot Bobbin Safety Feature Setthe Pressure Dial SettingSpool Pins AccessoryStorage Box Free-Arm Sewing the Removable Extension Table To removeOranycirculargarmentarea Orareasofwearinchildrensclothes Etc Check Your PresserFoot Presser Foot Types Zigzag Foot PresserFoot Types SlidingButtonhole Foot Uses Zipper application see Buttonhole Foot LookTo Change Your Needle To Remove the Bobbin from the Machine Wind the Bobbin Thread Threading chart is located behind Face cover plateInsert the Bobbin into the Bobbin Holder ThroughOn the illustrations Threads under PresserLeaving Adjust the Top Thread Tension Too Tight Too Loose ZigzagRickrack stretch Reverse Practical Stitch Chart On p.14On p Thread Stitch Tension LengthOnp.14 On p.14 CheckOn p Buttonhole Use the Seam Guides Stitch length controt orangeHeresHow Lower the presser foot Set the MachineControl ChildrensBasic Zigzag Control I to= Satin Stitch Control 2 toSatin stitch foot Pressuredial t or Bar Tacking No preer WLdth=dth FootPlate EitherTop thread tension Contro! 3 to = Overcasting StitchControl 3 to Hints@i 3 Overcast Stretch Stitching Set the Machine Control 2 to 6Stitch tength controt yellow stretch st=tchZigzag toot Control 9 to 6Stitch length control orange Iiilii!!iii!iiii Stitch width control 2 toTips on buttonholing = Learning to Sew ButtonhoesPlaced 311 Control Built-in SystemControl 3 to 5 Blue zone Top thread tensionIlii!iii!!ii!i Template 213504005 213505006 213506007 318 112 Using Buttonhole AttachmentButtonhole Style and Size 1116 718 11t6 SizesSet the Machine Stitch width Nhote toot Stitch length control Top thread tension control 2 to Open Ztpper Close Zoper Turn Remove Zipper Stitch width Control 3 to Control Orange zoneSet the Machine Stitch Wdth EasierIiiiiiiiii iiii!iiiiiiiiiliiiiiiiii!!iiii!ii¸iii!!i ii Elastic Stretch Stitch Edging stitch Top thread tension control 3 toStitch length control 9teen Incorrect SeamProblem Probable Cause IReplaetleigh=,Btii Iean7,theBo6 bl nHOtde riiPage Parts List 647814053 No Single 647814031 No Single647814042 Single 652806014 Straight Toot 685502019Hand wheel Herring Bone stretch Hook Race Control Straight Stitching 2829Application 4849 Foot 4849 6061Warranty SEARS, Roebuck and CO., D1817 WA, Hoffman Estates, ILSewing Machine 385