Sears 385. 11607 owner manual Pate for, See p

Page 28

SECTION 3. LEARN THE STITCHES

=Sew a Button

Set the Machine

Stitch

Stitch selector

(Mo6e! 12714)

Top thread tension

contro_ I to 4

(Model 116071

Stitch length control any number {not necessary to adjust)

Zigzag foot

Darnrag piate

Use	the	darning	p_ate for	button	sewing	(see p. 22).
1.	Set	the stitch	selector	at"	'	"

2, Align both holes of the button with the slot of the foot and place the _eft hote of the button just below the needle point.

To strengthen the shank, cut the threads leaving a 20 cm (8") tail, BrEng the needle thread down through the hole in the button and wind it around the shank.

3.Lower the foot and turn the stitch selector to zigzag until the needle point comes just above the right hole of the button.

4, Sew about five stitches and raise needle,

5. Set the stitch selector at " ci_ "agmn and sew a few stitches to lock thread.

Draw the thread to the bottom side and knot_

26

Image 28

Contents Sewing Mach SEARS, Roebuck and CO Kenrnore Sewing MachineOr injury to persons ImmediatelyContents Know the Machine Section KNOW-EHE Machine AccessoriesIdentify Set Up the Machine Prepare the Machine for SewingPosition Choose the Needle and Thread = To Changethe NeedleCorrect Presser PositionNeedles SewingBlue Orange 1 Red Prepare the Bobbin = To Remove the Bobbin Case from the MachineWhen latch ts released Case should lock into placePrepare the Top Thread Pick Up the Bobbin Thread Threads underAdjust Top Thread Tension O7OReverse Stitch Control WithoutStitch Selector ModelAdjustingStretchStitch Balance Model 12714 only Iil Jso,,i.0Preparethemachineforsewing Learn the Stitches Straight StitchesLeft Needle Position = Sew in a Zipper Fabric Preparation Control 3 toIiii Use the Darning Plate HeresHowDarning Zigzag Stitches Control t to = Satin StitchStitch length control 0.5 to Zigzag Stitches Bar TackingPate for See pZigzagStitches Section Learn Stitches Zigzag StitchesBlind Hemming Control 3 to g Box StitchingStretch Stitches Model 12714 only Rick-Rack Stretch Model 12714 onlyControl 1 to Top thread tens=on StitchStretch PreventsMachine = Elastic Stretch Stitch Model 12714 only Set the MachineButtonholes Stitch Performance Problems Chart Check bobbin case threading Clean bobbin case and shuttleWhat to Do When Machine Jamming Knocking NoiseWhat to Do When Probable CauseCleaning Section Care For MachineReplacing Light BulbImL Oiling Machine Care for the MachineOil the Underside 131415 17 18 19 J Index Pin*Tuck Foot 12641 12712 12714 12741 Gathering Foot12781 12841 16951 17622 Ruffler 17781 17881 Elastic FootJs.E Littleoilingfeeding FlatWarranty SEARS, Roebuck and CO., D/817 WA, Hoffman Estates, ILSewing Machine