Harbor Freight Tools 3914 operating instructions Assembly

Assembly

Sewing Machine

Table Stand and

Top (not provided)Power Switch

Motor Knee Lifting Arm for Presser Foot

Figure 1

The assembly instructions describe mounting the Single-Needle Sewing Machine (Model 03914) to the Table Stand (Model 03929), not included. In order to complete this procedure, you must first purchase and assemble the Table Stand Kit (Model 03929).

Installing the Oil Pan and Sewing Machine to the Tabletop of Industrial Sewing Machine Table (SKU 3929 - sold separately)

Oil Pan (1g) hole in Tabletop (30)

Rubber Pads (23g)

Corner Rests

Rubber Cushions (24g)

(Operator Side of Table)

Rubber Pads (23g)

Rubber Cushions (24g)

Figure 2

1.Working in the rectangular hole of the Tabletop where the Oil Pan (1g) will sit: Place the Rubber Cushions (24g) on the operator-side corner rests, and the Rubber Pads (23g) on the hinge-side corner rests. Secure with two Tacks (25g) in each Pad or Cushion.

Note: The Rubber Pads (23g) are optional. They may be omitted, or used under the Rubber Cushions (24g) to adjust the tilt

REV 07f, 10b

of the machine, depending on the user’s preference.

Hinge Indentations in Tabletop

Back of

Sewing

Machine

Oil Pan (1g)

Hinge (1h)

Figure 3

2.Seat the Oil Pan (1g) on the Rubber Pads and Cushions in the Tabletop opening.

3.Insert the Hinge Cushions (2h) into the tabletop, securing them with two Tacks (25g) in each Hinge Cushion.

4.Insert the Hinges (1h) into the holes in the back of the Sewing Machine.

Machine Rest

Pin (19h)

Figure 4

5.Insert the Machine Rest Pin (19h) in the hole provided in the table stand.

6.Carefully place the machine, hinge side first, into the Rubber Hinge Plates and over the Oil Pan.