Model SB1016/SB1036 | P R E P A R A T I O N | For Machines Mfg. Since 7/09 |
Preparation Overview
The purpose of the preparation section is to help you prepare your machine for operation. The list below outlines the basic process. Specific steps for each of these points will be covered in detail later in this section.
The typical preparation process is as follows:
1.Unpack the lathe and inventory the contents of the box/crate.
2.Clean the lathe and its components.
3.Identify an acceptable location for the lathe and move it to that location.
4.Level the lathe and either bolt it to the floor or place it on mounts.
5.Assemble the loose components, lubricate the lathe, and make any necessary adjustments or inspections to ensure the lathe is ready for operation.
6.Connect the lathe to the power source.
7.Test run the lathe to make sure it functions properly and is ready for operation.
Things You'll Need
To complete the preparation process, you will need the following items:
For Lifting and Moving
ss4WOWEXTRAEPERSONSAWITH GUIDE RODSSTO STEADYH the lathe during lifting and moving.
ss!!&ORKLIFT ORL/THERT0OWERR,IFTINGHDEVICE rated for at least 10,000 lbs.
ss,IFTINGTStrap or Chain with Hook rated for at least 10,000 lbs.
ssVarious Hardwood Blocks and Planks as Needed
For Power Connection
ss!!POWEROSOURCE THATOMEETSCTHE MINIMUMT circuit requirements for this machine (refer
to Page 16 for details).
ss!!QUALIFIEDLELECTRICIAN TO ENSURETARSAFE AND
For Assembly
ss0RECISIONI,EVEL ss Cotton Rags ss Mineral Spirits
ss Quality Metal Protectant Oil ss 3AFETY Glasses
ss Wrench or Socket 21mm ss Wrench or Socket 19mm
ss &LOOROMounting Hardware as Needed ss Standard Screwdriver #2
