For Machines Mfg. Since 7/09 | M A I N T E N A N C E | Model SB1016/SB1036 |
Checking & Adding Oil
Oil Type...Mobil DTE Light or ISO 32 Equivalent
Oil Amount | 4 Gallons |
Check/Add Frequency | Daily |
Change Frequency | Annually |
The oil sight glass shown in Figure 116 is to verify that oil is being pumped into the headstock during operation. When the lathe is disconnected from power, no oil will be seen in the sight glass. Adding oil is done at the oil tank filler cap shown in Figure 119.
Headstock Oil
Flow Sight Glass.
Tank Filler Cap
Figure 116. Headstock oil flow sight glass location.
The oil tank filler cap is fitted with a dip stick for checking the headstock oil level as shown in Figure 117.
Full Zone
Add Zone
Figure 117. Headstock oil level dip stick.
Changing Headstock Oil
The headstock oil pump system must be cleaned and the oil changed after the
Since this lathe uses a
Items Needed: |
| Qty |
1 | ||
Phillips Screwdriver #2 | 1 | |
Standard Screwdriver #2 | 1 | |
Funnel 8" | 1 | |
Hex Wrench 4mm | 1 | |
Wrench 17mm | 1 | |
Wrench 25mm | 1 | |
Wrench 11⁄2" | 1 | |
Mineral Spirits | As Required | |
Rags | As Required | |
Gasket or Automotive Silicone Sealant | 1 | |
Hose Clamp | 1⁄2" Dia. | |
Rubber Drain Hose | 3⁄8" ID x 4' Long | |
Magnets | Optional |
To to change the headstock oil:
1.DISCONNECT LATHE FROM POWER!
2.Remove the end gear cover, the tank cover (see Figure 118), and remove the oil tank filler cap (see Figure 119).
End Gear Cover
Tank Cover