For Machines Mfg. Since 7/09 | O P E R A T I O N | Model SB1016/SB1036 |
9.Use calipers to measure both ends of the workpiece.
—If the machined workpiece is thicker at the tailstock end, move the tailstock toward the operator 1⁄2 the distance of the amount of taper (see Figure 70).
Move the tailstock toward |
the operator half the |
distance of the taper. |
Looking down from above. |
Figure 70. Adjust tailstock toward the operator.
—If the machined workpiece is thinner at the tailstock end, move the tailstock away from the operator 1⁄2 the distance of the amount of taper (see Figure 71).
Looking down from above. |
Move tailstock away from |
the operator half the |
distance of the taper. |
Figure 71. Adjust tailstock away from the operator.
10.Repeat Steps
