Model SB1016/SB1036

M A I N T E N A N C E

For Machines Mfg. Since 7/09

Maintenance Schedule

!

Always disconnect power

to the machine before

 

performing maintenance.

 

Failure to do this may

 

result in electrocution or

 

accidental startup injury.

Typically, each operator is responsible for ensuring proper care of the equipment. We strongly recommend all operators make a habit of following the daily maintenance procedures.

For optimum performance from this machine, this maintenance schedule must be strictly followed. Use the chart provided on Page 65 to ensure this is done.

Ongoing

To maintain a low risk of injury and proper machine operation, if you ever observe any of the items below, shut down the machine immediately and fix the problem before continuing operations:

ss ,OOSEOMOUNTING BOLTS ORIFASTENERS

ss7ORN RFRAYED FCRACKED OR DAMAGEDAWIRES ss 'UARDS REMOVED

ss 3TOP BUTTONBNOTTWORKING CORRECTLYWOR NOT requiring you to reset it before starting the machine again.

ss !!REDUCTIONUIN BRAKING SPEED ORBEFFICIENCY ss (EADSTOCKSOILONOTKFLOWINGLAGAINSTTSIGHTLGLASS ss #UTTINGT&LUIDGNOT&FLOWINGDOUTNFROM NOZZLE ss Any other unsafe condition.

Daily, Before Operations

ss#HECKADDKGEARBOXDOILGPage 69). ss #HECKADDKAPRONDOIL Page 70).

ss #HECKECUTTINGCmUID LEVEL Page 73). ss ,UBRICATEITHEAWAYS Page 70).

ss 0UTUOIL IN THE BALLNOILERS Page 71).

ss #LEANLUBRICATEUTHERLEADSCREWEPage 70). ss 4URN SPINDLE SPEED DIALEALLSTHEEWAYDDOWN ss -OVE THE POWER FEEDPLEVEREON THE APRON TOL neutral (to prevent crashes upon startup).

ss %NSURE CARRIAGECLOCK ISILOOSE

Daily, During Operations

ss6ERIFY HEADSTOCK OIL mOWSTWHEN POWER ISL turned ON (Page 66).

Daily, After Operations

ss 6ACUUMCLEAN ALL CHIPS AND SWARF FROMHBED slides, and chip drawer.

ss7IPE DOWN ALLOUNPAINTEDLOR MACHINEDA surfaces with an oiled rag (Page 71).

ss0USH THE STOPHBUTTON AND SHUTBOFF the master power switch (to prevent accidental startup).

Monthly

ss$RAINAANDNCLEANNTHE CUTTINGAmUID TANK THENU add new cutting fluid.

Annually (or Semi-Annually with Hard Use)

ss$RAINAANDNCLEANNTHE HEADSTOCKNOILTRESERVOIR then add new oil.

ss#HANGE THE APRON OIL ss #HANGE THE GEARBOX OIL

ss $ISCONNECT MACHINE FROMMPOWER OPENE electrical box, and clean with compressed air or a vacuum.

Cleaning

Regular cleaning is one of the most important steps in taking care of this lathe. We recommend that each operator be responsible for cleaning the machine immediately after using it or at the end of the day. We also recommend that the cleaning routine be planned into the workflow schedule, so that adequate time is set aside to do the job right.

Typically, the easiest way to clean swarf from the bed ways and chip drawer is to use a wet/dry shop vacuum that is dedicated for this purpose only. The small chips leftover after vacuuming can be wiped up with a slightly oiled rag. Avoid using compressed air to blow off chips, as it may drive them deeper into moving surfaces and could cause sharp chips to fly into your face or hands.

All visible swarf should be removed from the lathe during cleaning.

-64-

Page 66
Image 66
Southbend sb1016 owner manual Maintenance Schedule, Cleaning