Southbend sb1016 owner manual Cutting Fluid System, To use the cutting fluid system on your lathe

For Machines Mfg. Since 7/09 O P E R A T I O N Model SB1016/SB1036

Cutting Fluid System

A pump delivers cutting fluid through a flex tube and nozzle. The pump is turned ON/OFF by the cutting fluid pump switch on the control panel. Flow is controlled by the valve lever on the flex tube (see Figure 107).

Nozzle

Valve

Lever

Cutting Fluid

Pump Switch

Figure 107. Cutting Fluid system controls and

components.

Always use high quality cutting fluid in this lathe and follow the manufacturer's instructions for diluting. The quick reference table shown in Figure 108 can help you select the appropriate cutting fluid.

Refer to Cutting Fluid System on Page 73 for detailed instructions on how to add or change cutting fluid. Check the cutting fluid regularly and promptly change it when it becomes overly dirty or rancid, or as recommended by fluid manufacturer.

BIOLOGICAL & POISON

HAZARD!

Use the correct personal

protection equipment

when handling cutting

fluid. Follow federal, state,

and fluid manufacturer

requirements for proper

disposal.

Running the pump without adequate fluid in the tank may permanently damage it. This is abuse and is not covered by the warranty.

To use the cutting fluid system on your lathe:

1.Make sure the tank is properly serviced and filled with cutting fluid, and that you wear the necessary personal protection equipment.

2.Position the cutting fluid nozzle for your operation.

3.Use the control panel cutting fluid pump switch to turn the cutting fluid pump ON.

4.Adjust the flow of cutting fluid by using the valve lever near the base of the nozzle hose.

Note: Promptly clean any splashed cutting fluid from the floor to avoid a slipping hazard.

Workpiece	Dry	Water	Synthetic	Sulferized	Mineral
		Soluble Oil	Coolants	Oil	OIl
Aluminum		X	X
Brass	X	X	X
Bronze	X	X	X		X
Cast iron	X
Low Carbon Steel		X	X
Alloy Metals		X	X	X	X
Stainless Steel		X	X	X	X

General Note: Cutting fluids are used for heavy-duty lathe operations and production turning. Oil-water emulsions and synthetic cutting fluids are the most common for typical lathe operations. Sulferized oils often are used for threading. For small projects, spot lubrications can be done with an oil can or brush, or omitted completely.

Figure 108. Cutting Fluid selection table.

-61-