For Machines Mfg. Since 7/09 | O P E R A T I O N | Model SB1016/SB1036 |
K.Cutting Fluid Pump Switch: Start/stops the cutting fluid pump motor.
L.Jog Button: Turns the spindle motor ON while being pressed and held.
M.Stop Button: Stops all machine functions. Twist clockwise to reset.
Carriage Controls
| Q |
|
|
|
|
| R |
P |
|
|
|
| S | T |
|
O | W |
| |
N |
| U |
|
|
|
| |
|
| V | X |
|
|
| |
| Z |
|
|
| Y |
|
|
Figure 40. Carriage controls.
N.Carriage Handwheel: Moves the carriage parallel along the ways, and can be disengaged when power feed operations would make it an entanglement hazard.
O.Cross Slide Handwheel: Moves the cross slide perpendicular to the ways into the workpiece.
P.Compound Slide Handwheel: Moves the tool in fine increments at compound angles.
Q .
R.Flow Control Lever: Controls the flow of cutting fluid from the nozzle.
S.Way Oil Oil Pump: Draws oil from the apron case and lubricates the carriage and ways through various oil ports.
T.Carriage Lock: Secures the carriage in place for greater rigidity and accuracy when using the cross or compound slide for the machining operation.
U.Thread Dial and Chart: Dial indicates when to engage the half nut during threading operations. Chart indicates on which thread dial reading to engage the half nut for specific inch or Whitworth thread pitches.
V.Feed ON/OFF Lever: Engages and disengages the longitudinal and cross feed system at the apron.
W.Half Nut Lever: Engages and disengages the half nut for threading operations.
X.Spindle ON/OFF Lever: Starts, stops and reverses direction of spindle rotation.
Y.Apron Feed Direction Knob: Changes direction of carriage feed or the cross slide feed without having to stop the lathe and move the headstock feed direction lever.
Z.Feed Selection Knob: Selects either the carriage feed or the cross slide feed.
AA.Feed Clutch: This adjustable clutch helps protect the feed system against broken gears and shafts caused by accidental overloads.
AA
