Janome JP760 manual Dropping the Feed Dog, Changing the Presser Foot

		Dropping the Feed Dog
		The feed dog can be lowered with the drop-feed lever
w		for sewing on buttons etc.
	e	Shift the drop-feed lever to the right to lower the feed
q		dog.
q		Shift the lever to the left to raise the feed dog, it will

return to the up position when the machine is started.

w		q Up position
		w Down position
		e Feed dog
	r	r Hand wheel

NOTE:

The feed dog should be in the up position for regular sewing. Turn the handwheel toward you to check if the feed dog comes up after setting the lever in the up position.

q

we

r

Changing the Presser Foot

CAUTION:

Turn OFF the power switch before changing the foot. Always use the proper foot for the selected pattern. The wrong foot can cause the needle to break.

Do not push the lever down to prevent it from being broken.

To snap off:

Raise the needle and presser foot.

Press the lever on the back of the foot holder and the foot will drop.

qLever

To snap on:

Place the presser foot so the pin on the foot lies just under the groove of the foot holder.

Lower the foot holder to lock the foot in place.

wGroove e Pin

Each foot is marked with a letter for identification.

rIdentification Letter

q

w

r e

Detaching and Attaching the Foot Holder

WARNING:

Turn OFF the power switch before detaching or attaching the foot holder.

To detach:

Raise the presser bar and turn the setscrew counterclockwise to remove the foot holder.

qSetscrew w Foot holder

To attach:

Align the hole in the foot holder with the threaded hole in the presser bar and insert the setscrew through the hole.

Tighten the setscrew by turning it clockwise.

eHole

rThreaded hole

8