Pfaff Embroidery Mode-Stitch-Out manual Common embroidery stitch-out pop-ups, Attach correct hoop

Common embroidery stitch-out pop-ups

Embroidery unit calibration

When the embroidery unit is attached, a pop- up asks you to slide off the hoop and clear the machine area for calibrating the embroidery arm. You will also be reminded to snap on the embroidery presser foot 6A.

Note: It is very important to remove the hoop, otherwise the hoop or the embroidery unit may be damaged while calibrating.

Attach correct hoop

If the size of the hoop attached to the machine does not match the size displayed on screen, the machine will not embroider. You must change the hoop to the displayed size or change the hoop setting to the hoop size attached.

To change hoop settings, re-enter embroidery edit and go to select hoop.

Bobbin empty

When the bobbin is almost empty, the machine stops automatically and a pop-up appears on the screen.

Note: It is possible to embroider until the thread has completely run out. Press the start/stop button to continue embroidering without closing the bobbin empty pop-up.

Close the pop-up. Replace the empty bobbin with a full one. Pull back excess needle thread and move a few stitches backwards using the current stitch icons (3). Start embroidering again by pressing the start/stop button or the foot control.

Note: Use the bobbin position to get easier access to the bobbin. When the bobbin is replaced, touch current position to move the hoop back to where the embroidery stopped.

Check needle thread

The machine stops automatically if the needle thread runs out or breaks. Re-thread the needle thread, close the pop-up, step back a few stitches and start embroidering again.

3

Embroidery mode - stitch-out

9:9