Cleaning and maintenance | 47 |
Cleaning
If the sewing computer is stored in a cold room, it should be brought to a warm room about one hour before use.
Cleaning
Clean the sewing computer after every use
•turn power switch to 0
•remove presser foot and needle
•open the
•unscrew the stitch plate (with screwdriver TORX)
•lift and remove it
•clean the area with the brush
•replace the stitch plate
Cleaning the screen and the sewing computer
•wipe with a damp cloth
CAUTION |
Disconnect plug |
from the socket |
before cleaning |
and servicing |
Cleaning the hook
•turn power switch to 0
•remove the bobbin case
•push the release lever to the left
•push the locking lever to the left and fold down the hook race cover
•remove the hook
•clean the hook race with a cloth or brush, never use a sharp instrument
•replace the hook, turning the handwheel if necessary so that the hook driver is on the left
•close the hook race cover and secure with the locking lever, the locking pin must engage
•check by turning the handwheel
•insert the bobbin case
Lubricating
This sewing computer is equipped with a
LM (low mass) hook system which requires no lubrication.
If however you do lubricate any parts, always run the sewing computer immediately afterwards on scrap material to avoid soiling your work.
Important!
Never use alcohol, petrol, white spirit or any type of solvent to clean the sewing computer!
Refer to the safety instruction!
030595.50.04_0201_a125_EN