INSTALLING ROTO COVER AND CRANK
Note: Finish the interior of the window and allow the window to dry before proceeding with these instructions. (To open the window for finishing, partially insert the lock handle into the jamb, unlock the unit, temporarily attach the crank handle and turn to open.)
A.Place the cover over the operator stud and snap into place.
B.Apply pressure to the pocket end of the cover and snap into place.
C.Use a medium size
D.Slide the crank handle onto the stud. Unlock, open window, then close and lock window.
E.Fold the crank handle down and check alignment of knob with the pocket.
Note: You may need to adjust the crank position on the stud until the correct alignment is achieved.
F.Open the crank and tighten the set screw.
G.After the final installation, fold the crank over and snap the knob into the pocket.
Note: Even with the window open the crank can be folded to avoid interfering with the window treatments.
1PDLFU&OE | # | |
" | 0QFSBUPS4UVE | |
$SBOL)BOEMF % | ||
0QFSBUPS4UVE |
|
4FU4DSFX | $ |
,OPC | & |
1PDLFU |
LOCK LEVER REMOVAL AND INSERTION
Note: You may want to remove the lock lever prior to finishing the window, or if it needs to be replaced with a lock lever in a different finish.
A. Unlock and open the window. | *OUFSJPS | &YUFSJPS | |
|
| ||
B. Place the lock lever in the locked position. | # | $ | |
|
| ||
C. From the exterior of the window, insert a small flat |
|
| |
blade screwdriver into the slot behind the lock lever. |
|
| |
D. Pry the cam away from the side of the window by |
|
| |
rotating the screwdriver a quarter turn. |
|
| |
Note: This will release the hook in the lever from |
|
| |
the cam hook. | &YUFSJPS | *OUFSJPS | |
| |||
E. Remove the lock lever by pulling it toward the |
|
| |
interior of the building. | & |
| |
|
| ||
F. To install a lock lever, hold it in the lock position | % |
| |
and insert it, from the interior, into the slot until it | ' | ||
| |||
snaps into the cam. |
|
|