Operating Instructions, Figure P | Harbor Freight Tools 90178

INNER COVER (#23)

BOLT (#24)

FLAT WASHER (#10)

SPRING WASHER (#9)

NUT (#8)

ENGINE COVER (#25)

FIGURE P

OPERATING INSTRUCTIONS

1.IMPORTANT: ALWAYS make sure the crankcase of the gasoline Engine (part #14) is filled to the proper level with a premium quality, 30-weight, non-detergent engine oil prior to starting the engine. Failure to do so will result in damage to the Engine and void its warranty. Refer to the Engine manufacturer’s instruction manual for further information.

CAUTION: NEVER REFILL THE ENGINE’S FUEL TANK WHILE THE ENGINE (PART #14) IS RUNNING.

2.CAUTION! Do not attempt to move the Cement Mixer when it is full and/or in operation.

3.Place the Cement Mixer on a solid, flat, level surface that is capable of support- ing the weight of the Mixer and its load.

4.Start the Engine (part #14), and allow it to reach the appropriate operating speed and temperature as instructed in the Engine manufacturer’s operating manual.

5.NOTE: Filling and emptying the Drum (parts #44, #47) is best done with the Drum rotating. Do not turn off the Cement Mixer while full of cement.

6.With the Drum (parts #44, #47) operating between 20-36 RPM, the Cement Mixer is now ready for the addition of the cement mix.

7.To determine the proper amount of water, gravel, cement, and sand, refer to Figure Q, next page.)

SKU 90178

PAGE 15