WHEEL (#5)
FLAT WASHER (#3)
FIGURE B | PIN (#4) |
Washers (part #10), two Spring Washers (part #9), and two Nuts (part #8). (See Figure C.)
LOWER DRUM (#44)
HEX BOLT (#7)
FLAT WASHER (#10) SPRING WASHER (#9)
NUT (#8)
HEX BOLT (#7)
FLAT WASHER (#10) SPRING WASHER (#9)
NUT (#8)
SUPPORT ARM (#31)
FIGURE C
4.Align the two mounting holes in the Degree Adjusting Plate (part #37) with the two mounting holes located on the upper right side of the Support Arm (part #31). Then attach the Degree Adjusting Plate to the Support Arm, using two Hex Head Bolts (part #27), two Flat Washers (part #10), two Spring Washers (part #9), and two Nuts (part #8). (See Figure C, and Figure D, next page,)
5.Insert the Spring (part #39) into the lower portion of the Degree Adjusting Arm (part #38). Then, insert the Degree Adjusting Arm onto the Pivot Shaft of the Degree Adjusting Plate (part #37). See Figure D.)
SKU 90178 | PAGE 7 |