Mirror Wiring | Chevrolet 6405/4410TK, Power Vision guide

6405/4410 Install PAGE 4

4.Repeat steps 1 through 3 for the passenger side identifying the right side active turn signal wire (recommend trying dark blue w/white tracer wire) and tapping the passenger mirror into it using a scotchlok.

5.Take the black wire from inside the driver side two-strand harness that you have run into the cab and the black wire from the passenger side and crimp them together in the ring terminal provided. The turn signal system can then be grounded under the dash.

6.Test the turn signal system by turning on your turn signals and checking to see that the turn signal indicators in the mirror glass light up. If they do not, re-check to see that you have scotchloked into the correct wires.

MIRROR WIRING:

(BEFORE YOU START THE WIRING PROCESS, PLEASE DISCONNECT THE NEGATIVE CABLE FROM THE BATTERY)

1.Using the templates and measurements provided with your switch kit assembly, prepare the driver side trim panel for the in/out switch and glass tilt switch.

In/Out Rocker Switch: We recommend placing the in/out switch on the triangular-shaped trim piece as shown. The center of the switch should be 2” from the left side of the trim and 2” from the bottom of the trim piece. If you choose to put it in another location, be sure to check the clearance before you cut the hole. You will need at least 1¼” clearance for the back of the switch. It is important to follow measurements on the diagram provided - - the switch should fit snugly, but not bind. If hole is cut too small it will cause the in/out switch to stick in a running position and burn the motors and/or the switch out. The in/out switch will be snapped into place later in the installation.

Glass Tilt Switch: We recommend placing the glass tilt switch on the driver’s side door trim panel, as shown. Make sure there is clearance on the back of the trim panel and you will need at least 1 5/8” depth for the glass tilt switch.