Desa SVYD18PRA, SVYD18NRA installation manual Bolt Stop

INSTALLATION

Continued

9.Remove log box and heater from carton. Place heater in stove as shown in Figure 9. Use bolts from hardware kit to attach heater to stove.

10.Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts) into threaded hole on stove body (see Figure 7). Use an adjustable wrench or a 12mm socket. The catch bolt has two hex nuts attached to it (see Figure 11). The top nut is a bolt stop and the bottom nut is for door leveling adjustment.

11.Check general catch bolt alignment with door claw. Make final adjustment and door level- ing after stove is in normal standing position.

12.Carefully lift stove back up on its four attached legs.

13.Remove gas log heater from carton. Note: Do not pick up gas log heater by the burner itself. This could damage heater. Always handle the gas log heater by the heater base only.

14.Fasten stove pan to stove with two (2) M6 x 1 - 25mm bolts. Use a flat washer and lock washer with each bolt. Tighten bolts into threaded holes on stove body (see Figures 7 and 9). Use an adjustable wrench or a 10mm socket.

15.Set top grates into stove top.

		Door Catch Bolt
		With Adjustable
Door Hinge		Hex Nuts Hole
Step Bolt Hole	Front	Leg Hole
Leg
Hole

Holes for

Stove

Bottom

Leg Hole	Leg Hole Bottom Of
	Stove Unit

Figure 7 - Locating Threaded Holes for

Stove Bottom, Legs, and Door

Attachment (Appearance May Vary

Depending on Model)

Bottom Of

Stove Unit

Washers

Bolt

Leg

Figure 8 - Attaching Stove Legs

(Oxford™ Model Shown)

Bolt

Washers

Stove Pan	Threaded Holes
	in Stove Body

Figure 9 - Attaching Stove Pan

(Oxford™ Model Shown)

Stove

Door Threaded

Hole

Door

Hinge

Step
Bolt
Bolt Shoulder	Stove
	Bottom

Figure 10 - Attaching Stove Door

(Appearance May Vary Depending on Model)

		Bolt Stop
Door		Adjusting
	Door	Nut
	Claw	Catch
		Bolt

Figure 11 - Catch Bolt and Door Claw

Orientation

10 www.desatech.com 113084-01C