Drolet 1200, 2000, 1600 owner manual Benefits of Installing a Blower

Page 11

THE BENEFITS OF INSTALLING A BLOWER

A blower can be installed at the back of your DROLET stove. This option is necessary if you wish to redistribute into a room the heat trapped at the back of your stove. By forcing hot air toward the front, the blower enables you to extend the radiation power of your stove.

You can purchase this option through your DROLET dealer. Make sure to specify this part number: #AC02050. You can also install a thermodisc to enable the blower to start or stop automatically when the stove is hot or too cold. The thermodisc part number is AC05530. Installation instructions are supplied with the blower and the thermodisc.

10

Image 11

Contents Read and Keep this Manual for Reference SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000Table of Contents Introduction SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000 Technical SpecificationsPedestal and Decorative Sidewall Installation AssemblySIBERIAN-1200 Bricks Installation SIBERIAN-1200SIBERIAN-1600 Refractory Bricks Assembly Bricks and Insulation Installation SIBERIAN-1600Siberian 2000 Refractory Bricks Assembly Brick and Insulation Installation SiberianAir Tubes Installation AIR Tubes Installation SiberianDoor Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Canada ClearancesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsClay liner Thimble Clean out Door Factory Built Thimble Brick Thimble Average Energy Yield Of One Air Dried Cord Of Cut Wood Woodstove UtilizationIgnition Testing Your WoodFirst Fires Low Medium High HeatingCreosote Formation and Need for Removal ReloadingASH Disposal Paint MaintenanceGlass GasketingDescription Warranty Application Limited Lifetime Warranty