Drolet 1600, 2000, 1200 owner manual Floor Protector

Page 13

FLOOR PROTECTOR

Your wood stove should be placed on a non-combustible surface. The floor protector should be under the stove, eighteen inches beyond the front and eight inches beyond each side of the fuel loading and ash removal opening. If there is a horizontal section of chimney connector, the floor protector should go under it and two inches beyond each side.

The floor protector should exceed the stove as follows:

FRONT SIDES BACK

18’’ 8’’ 8’’ (460 mm) (200 mm) (200 mm)

Image 13

Contents Read and Keep this Manual for Reference SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000Table of Contents Introduction SIBERIAN-1200 SIBERIAN-1600 SIBERIAN-2000 Technical SpecificationsPedestal and Decorative Sidewall Installation AssemblySIBERIAN-1200 Bricks Installation SIBERIAN-1200SIBERIAN-1600 Refractory Bricks Assembly Bricks and Insulation Installation SIBERIAN-1600Siberian 2000 Refractory Bricks Assembly Brick and Insulation Installation SiberianAir Tubes Installation AIR Tubes Installation SiberianDoor Adjustment Door AdjustmentBenefits of Installing a Blower Positioning the Stove InstallationFloor Protector Canada ClearancesType of Protection Reduced ClearancesChimney Chimney Connector Stove Pipe Factory Built Chimney Typical InstallationsClay liner Thimble Clean out Door Factory Built Thimble Brick Thimble Average Energy Yield Of One Air Dried Cord Of Cut Wood Woodstove UtilizationFirst Fires Testing Your WoodIgnition Low Medium High HeatingCreosote Formation and Need for Removal ReloadingASH Disposal Glass MaintenanceGasketing PaintDescription Warranty Application Limited Lifetime Warranty