Installation
OPTIONAL FAN INSTALLATION:
This appliance when installed, must be electrically connected and grounded in accordance with local codes or in the absence of local codes, with the current CSA C22.1 CANADIAN ELECTRICAL CODE. Part 1, SAFETY STANDARDS FOR ELECTRICAL INSTALLATIONS, or THE NATIONAL ELECTRICAL CODE ANSI / NFPA 70 in the USA.
CAUTION
Label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing.
1) Remove the fan assembly from the box and inspect
for any damage to the assembly. Contact your dealer or 
courier if there is damage.
2) Remove the knock out at the bottom of the back panel of the appliance by using a flat head screwdriver as a lever, hook the tip of the screwdriver under the panel beside the tabs and push the panel out.
3) Install two (2) screws into the top two holes. Place the blower assembly over these two (2) screws and
tighten. Install the two (2) bottom screws and tighten.
4) Plug the fan assembly in and check for proper operation.
DO NOT cut or remove the grounding prong from the plug. DO NOT route the power cord beneath the heater.
WARNING: This appliance is equipped with a
WIRING DIAGRAM:
This is a basic wiring diagram for the option fan installation.
1)Plug the fan assembly into a three- prong (grounded) receptacle.
2)Turn the fan controller to the desired setting.
3)Once the unit has reached operating temperature, the fan temperature sensor will turn the fan on automatically.
4)When the unit cools down the fan temperature sensor will shut the fan off automatically.
����� | ��� |
|
|
| |
����� |
| ����� |
|
| |
| ����� |
|
��� |
|
|
����������� | ����� ������ |
|
������ | ��� | |
|
| |
|
| ���������� |
16