Installation
REMOVAL OF THE SHROUDS - INSERT:
Figure 49: Removal of right pod.
1.If the surround panel is installed, remove it by lifting the panel straight up then out.
2.For the right shroud, twist the handle on the air control clockwise to remove it from the rod.
3.Pull unit forward a few inches, if possible.
4.The shrouds can be removed one of two ways:
a.For the first method, pull the inside edge of the shroud straight out, approximately 3⁄4” (2cm), in order to unhook the shroud from unit. Pull the shroud out through the side.
b.For the second method (recommended for the right shroud), remove the two (2)
5.To install the shroud, follow steps 1 through 4 in reverse order. Ensure the shrouds are hooked behind both screws on either side.
INSTALLATION OF THE DECORATIVE PLATES - INSERT:
1. Remove the shroud from the unit (refer to “REMOVAL OF THE SHROUDS -
INSERT”)
2. Remove the fan from the left shroud (refer to ”FAN REMOVAL - INSERT”)
3. Unfasten the two (2) nuts that secure the plate to the shroud. The nuts should only be
4. Remove the old plate and replace with a new decorative plate.
5.
6.
7.
Figure 50: Changing
decorative plate.
38