Assembly and Installation
P38+ Pellet Stove
Unpacking
Cut straps holding box together and remove box from
skid.
The 38+ is bolted to the skid to prevent movement dur- ing shipping.
To free the stove from the skid you must remove the
Installing Rear Cover Panels
The rear cover panels are removed from the stove to make it easier to get at the
The rear cover panels are packed inside the hopper and should be installed on the stove as shown. This should be done after the stove is in place and flue is connected.
Firebrick
Install the firebrick horizontally on the angle above the burnpot.
Rear Cover
Panels
Flame Guide
Install the cast iron flame guide on top of the burnpot and make sure it is fully seated against the auger opening. The bottom of the flame guide is marked 38+.
4