5.Set the LP Cylinder a flat and level surface with the outlet valve facing toward the back of the stove.
6.Check that the cylinder valve is closed by turning the cylinder knob clockwise to a full stop (Fig. 26).
Fig. 26
7.Check that both stove control knobs are in the off position (Fig. 27).
Fig. 27
8.Remove the protective caps from the cylinder valve and coupling nut. NOTE: The coupling nut connects to the large outside threads on the valve outlet.
9.Hold the hose in one hand and insert the nipple into the valve outlet. Be sure the nipple is centered in the valve outlet.
No Smoking
Fig. 28
10.Turn the coupling nut clockwise, tighten to a full stop. If you cannot complete the final connection, disconnect the coupling nut and repeat steps 8 and 9. If you are still unable to complete the connection, DO NOT use this hose and valve!
11.Check that the hose has no kinks or sharp bends and clears areas that will become hot during use. Never put strain on the hose where it joins a fitting.
12.BEFORE lighting stove, check all connections for leaks using the procedure as shown in the section titled “LEAK TESTING”.
WARNING
•The gas hose is a tripping hazard. Keep yourself and others away from the gas hose when in use or attached to an appliance.
•Do not tip or move the fuel supply.
20” to 24”
•Turn off fuel at the cylinder and disconnect both ends of the hose when not in use.
•You must follow these instructions exactly or a fire causing death or serious injury may occur.
Fig. 29
Dismantling High Pressure Hose
•Before dismantling the high pressure hose, be sure gas pressure in the hose is eliminated.
•Ignite stove and turn off gas valve on cylinder.
•Allow flame to
•When flame is out, close valves on appliance.
•Remove hose.
Leak Testing - Refillable
Cylinders
DANGER
TO PREVENT FIRE
OR EXPLOSION HAZARD:
•NO SMOKING. DO NOT use or permit sources of ignition in the area while doing a leak test.
•Perform leak tests outdoors only.
•NEVER perform a leak test with fire or flame.