Breckwell P24I, P24FS owner manual Troubleshooting Guide

Page 28

28

TROUBLESHOOTING GUIDE

• GLASS “SOOT’S” UP AT A VERY FAST RATE

• FLAME IS LAZY, DARK, AND HAS BLACK TIPS

• AFTER STOVE HAS BEEN ON FOR A WHILE, THE BURNPOT OVERFILLS

Possible Causes:

Possible Remedies:

 

 

 

1.

Stove or vent pipe is dirty, which restricts airflow through the

Follow all cleaning procedure in the maintenance section of the

 

burnpot.

owner’s manual.

 

 

 

2.

Vent pipe installed improperly.

Check to make sure the vent pipe has been installed according to

 

 

the criteria in the owner’s manual.

 

 

 

3.

Air damper is set too far in (closed) for a higher setting.

Pull the damper knob farther out away from the side of the stove and

 

 

try to burn the unit again.

 

 

 

4.

Burnpot holes are blocked.

Remove the burnpot and thoroughly clean it.

 

 

 

5.

Air damper is broken.

Visually inspect the damper assembly. Make sure the damper plate

 

 

is attached to the damper rod. When the damper rod is moved the

 

 

plate should move with it.

 

 

 

6.

Blockage in air intake pipe.

Visually inspect the air intake pipe that leads into the burnpot for

 

 

foreign material.

 

 

 

7.

Circuit board malfunction.

Time the fuel feed light at each setting (after the stove has

 

 

completed the startup cycle). Make sure the times match the auger

 

 

timing chart. If the auger motor runs constantly, the board is bad.

 

 

 

8.

Combustion blower is not spinning fast enough.

Test the RPM on the blower after the blades have been cleaned.

 

 

The RPM should be approximately 3000 RPM.

 

 

 

9.

Bad Pellets

The brand of pellets or the batch of pellets that are being used may

 

(Applies to GLASS “SOOT’S” UP AT A VERY FAST RATE Only)

be of poor quality. If possible, try a different brand of pellets. You

 

 

might also want to try a brand that is made from a different type of

 

 

wood (softwood vs. hardwood). Different woods have different

 

 

characteristics when being burned.

 

 

 

10.

The trim setting on the low feed rate is to low

Use the “Reset Trim” button to increase the low feed rate setting. If

 

(Applies to GLASS “SOOT’S” UP AT A VERY FAST RATE Only)

the 1 & 4 are on, the stove is currently on the lowest setting. If only

 

 

the 1 light is on, the stove is in the default (medium) setting. If the 1

 

 

& 5 lights are on, the stove is in the high trim setting for the low feed

 

 

rate. If the stove is being burned on one of the two lower settings,

 

 

advance to the next trim setting and try burning the stove.

 

 

 

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Tradition Series P24 Introduction Important InformationSafety Precautions Table of Contents Installation SpecificationsPreparation ClearancesWhen Outside AIR is not Used Combustion AIR SupplyVenting Rear View P24FSA Rear View P24IEquivalent Vent Length EVL Freestanding InstallationHorizontally Through Wall refer to Figure Vertically with NEW Chimney System Refer to a & 9b Vertically Into Existing Chimney System Installation Through Side of Masonry Chimney Vertically Into Existing Masonry FireplaceInsert Installations Assembling the Flashing SETWhen Vent Pipe Extends to Chimney TOP AS a BUILT-IN Fireplace Installation in to a Factory Built Metal Fireplace Electrical InstallationSpecial Mobile Home Requirements Operation Proper Fuel PRE-START-UP CheckBuilding a Fire Hotrod Automatic FirestarterBreckwell Maintenance Tool Shutdown ProcedureSafety Features RE-STARTING a Warm StoveThermostat Installation Thermostat InstallationOptional Thermostat Millivolt Thermostat is RequiredPlease Read this Maintenance ASH RemovalASH Disposal Freestanding Models ASH Disposal InsertCleaning Vacuum USEBlowers Rear View P24FSChimney Cleaning Recommended Maintenance ScheduleRemoval and Replacement of Broken Door Glass Daily Weekly Annually or per TonMaintenance Stove Shuts OFF and the # 2 Light Flashes Troubleshooting GuidePossible Causes Stove Shuts OFF and the # 3 Light Flashes Stove Feeds PELLETS, but will not Ignite Possible Causes Possible RemediesSmoke Smell Coming Back Into the Home Convection Blower Shuts OFF and Comes Back onTroubleshooting Guide Troubleshooting Guide High Limit Switch Keeps Tripping Heat Level Setting P24Smoke Smell or Soot BUILD-UP Digital Circuit Board Timing RatesElectrical Diagram Replacement Parts BurnpotLifetime Limited Warranty
Related manuals
Manual 32 pages 37.58 Kb Manual 9 pages 26.02 Kb

P24FS, P24I specifications

The Breckwell P24FS is a highly efficient pellet stove designed to provide both warmth and ambiance to your living space. Renowned for its dependable performance, this appliance combines cutting-edge technology with elegant design, making it a popular choice among homeowners seeking sustainable heating solutions.

One of the standout features of the P24FS is its impressive heating capacity. With the ability to effectively heat up to 2,000 square feet, the stove is equipped with a powerful 40,000 BTU output. This makes it suitable for various living spaces, from cozy cabins to larger family homes. Its large hopper capacity allows for extended burn times, which means less frequent refueling and more convenience for users.

The P24FS is engineered with advanced features such as an automatic ignition system, which simplifies startup and enhances efficiency. This stove also comes with a built-in thermostat, allowing users to maintain a consistent temperature effortlessly. The adjustable feed rate gives homeowners control over the amount of pellet fuel consumed, enhancing both efficiency and comfort.

Breckwell has incorporated a wide array of technologies into the P24FS to ensure optimal performance and safety. The stove features a substantial heat exchange system, which maximizes heat distribution throughout the room, while the integrated air wash system minimizes the buildup of soot on the glass door, ensuring a clear view of the mesmerizing flames.

Another notable characteristic of the P24FS is its aesthetic appeal. With a sleek and contemporary design, it complements a range of interior styles, from rustic to modern. The durable construction, combined with quality materials, ensures longevity and resilience.

In terms of EPA certifications, the Breckwell P24FS meets stringent emission standards, making it an environmentally friendly option for heating. Users appreciate the convenience of using fuel pellets, which are not only renewable but also offer a cleaner burn compared to traditional wood.

Overall, the Breckwell P24FS is a blend of efficiency, style, and user-friendliness. Its array of features, high heating capacity, and commitment to sustainability make it an excellent investment for those looking to enhance their home’s heating system with a reliable pellet stove. Whether it's for functional heating or creating a cozy atmosphere, the P24FS stands out as a top choice among its peers.
Top Page Image Contents