Avalon Stoves Arbor PS manual Operation2, Loading Pellets, Two Modes of Operation

Operation2 1

Loading Pellets

Lift the hopper lid to its vertical position. Pour pellets into the hopper until full. NOTE: The hopper holds approximately 50 pounds of pellets.

To Open the Hopper Lid:

Lift the hopper lid from this handle.

Pe

ll

e

t

s

Warning: The front edge of the stove top becomes very hot, do not touch this

area below the handle.

NOTE:

The auger automatically shuts off when the hopper lid is open. If loading pellets while the heater is on, make sure to close the lid as soon as possible.

This prevents the heater from shutting off due to lack of pellets in the firepot.

H I N T: To prevent the pellet stove from inadvertently shutting down due to the auger disabling switch, we recommend pressing the “START” button after reloading the stove.

The Two Modes of Operation

Manual

Manual mode requires the user to turn the heater on and off manually.

Auto (requires a thermostat)

Auto mode allows you to use a thermostat to control room temperature. The stove automatically turns on when the temperature drops below the thermostat setting. Once the stove reaches operating temperature, the stove then runs at the heat output setting selected.

Switching Modes While in Operation

Whenever the stove is switched from one mode to another while in operation, the stove will enter the "start- up" sequence for a minimum of 20 minutes.

DISCONNECT POWER BEFORE SERVICE

H
E	REMOTE
A	HIGH
T	AUTO
O	MANUAL
	MED
U

TAUGER

P LOW

U		FAULT
T
		AUTO
H	UP	OFF
	MANUAL
E
A
T	DOWN	MANUAL
	UP	START

F

AMANUAL

N

DOWN

AUGER

TM

TRAVIS INDUSTRIES

HOUSE OF FIRE

NOTE: if using a modulating remote, this light will come on to indicate the remote is controlling the heater.

These indicator lights are used to determine which mode you are in.

Use the mode switch to determine the mode.

© Travis Industries 4070806 1 0 0 - 0 1 1 9 1 _ 0 0 0