Tools required for the Rack Mount installation are a T15 and T20 screwdriver. Prior to installation, make certain that the equipment cabinet is level.
CAUTION
Do not operate the LF 8600 in a position other than vertical (zero degrees tilt).
To install the Rack Mount configuration:
1.Install the platform support rack in an EIA standard
a.) Loosely secure the left and right Support Brackets to the rear integral slotted brackets on the platform support with two M4 screws each.
b.) Place the platform support in the desired vertical location in the cabinet and attach the front of the support directly to the front cabinet rails with four mounting screws (not supplied) which are compatible with your specific cabinet. Tighten securely.
c.) Slide the rear Support Brackets forward until they are positioned against the rear face of the rear cabinet rails. Tighten the M4 screws securely. These adjustable brackets allow for the adjustment of rail positions from 30 in. down to 20 in.
d.) Secure the Support Brackets to the rear cabinet rails with four mounting screws (not supplied) which are also
97663032 A Page 35