3.2.8 FAN AND MOTOR
1.Turn the nut left and full out the Fan by hands carefully.
2.Remove 2 screws that fasten Heat Exchange.
3.Lift the H/E and open the H/E around 45 degree clockwise carefully. (See Figure 22)
4.Unfasten 3 screws that secure the Motor and earth wire. (See Figure 23)
5.Remove the Motor.
3.2.9 SHROUD AND DRAIN PAN
1.Discharge the refrigerant by using a refrigerant Recovery System.
2.After purging the unit completely, unbrace the Discharge and the Suction tube connected compressor carefully.
3.Remove 2 screws that fasten the H/E.
4.Unfasten 2 screws that secure the shroud on the sides and then lift shroud from the drain pan. (See Figure 24)
5.Unfasten 2 screws that secure the drain pan to base pan. (See Figure 25)
6.Pull the drain pan backward then take it up from the base. (See Figure 25)
— 16—
Figure 22
Figure 23
Figure 24
Figure 25