1.5 CONTROL TYPE
1.5.1 Mechanical type
| 4 | 5 |
|
| 6 |
| |
| 3 | 7 | High |
|
|
| |
| 2 |
| 8 |
Auto | 1 | 9 | Low |
| |||
|
|
| |
| Off | Max | Fan Speed |
Humidity Control
•When you first use the dehumidifier, turn the humidity control to 5 or 6. If you still have moisture, turn the humidity control to a higher setting.
MAX is the highest setting.
•When excess moisture and dampness odors are gone, adjust the control to a lower setting. Use the dehumidifier as long as excess moisture is present.
Humidity Control
Auto Shut-Off
Figure 2
Fan Speed
• The fan control adjusts the fan speed. |
•This light glows when the bucket is full, or when the bucket is removed or not placed in the proper position. In these cases the Water Level Control Switch shuts off the dehumidifier.
•When the light glows, check the bucket condition.
Set the fan control to HIGH for maximum moisture |
removal. When the humidity has been reduced and |
quiet operation is preferred, set the fan control to |
LOW. |
1.5.2 Electronic type
Constantly On. |
| HUMIDITY |
| |
|
| BUCKET | ||
4hr. On/Off | High | CONTROL | ||
FULL | ||||
|
|
|
2hr. On/Off | Low |
AUTO RESTART
TIMER | FAN | HUMIDITY | POWER | |
SPEED |
|
| ||
SETTING
Figure 3
Fan Speed
•This controls the speed of the airflow.
•High: Fan speed is set to high.
•Low: Fan speed is set to low.
•When Fan Speed button is pressed, the fan speed mode is changed.
Timer
•Press this button to select type of operation.
•Select continuous On for uninterrupted operation.
•Select either 2 or 4 hr. On/Off for cycled operation: The unit will operate for 2 or 4 hours, and then shut off completely for 2 or 4 hours.
The cycle repeats until you change the setting.
•When Timer button is pressed, the Timer indicator lights shift as follow from 2hr.On/Off to 4hr.On/Off.
Bucket Full Indicator
•This light glows when the water bucket is full and needs to be emptied.
Power
•Operation starts when this button is pressed and stops when the button is pressed again.
Auto Restart
•Once power is restored after a power outage, the unit returns to its previous operation setting after a 2 minute delay.
The fan runs immediately when the power is restored.
Humidity Control
• This button controls the humidity in the room.
• Press | button to raise the humidity setting. |
• Press | button to lower the humidity setting. |
•The humidity setting can be set to a permanent "On" setting or to a specific humidity setting between 35% and 70% in 5% increments.
•"On" setting: Dehumidifier runs continuously regardless of humidity condition.
•35% - 70% setting: Dehumidifier runs on and off according to surrounding humidity conditions.
— 5—