Euro-Pro NP320 Checking for Blockages, Dust CUP, Filters PRE-MOTOR and Post Motor, Accessories

Checking for Blockages

Locking

Latch

Turbine

Wheel

Blockages may cause your vacuum to overheat and shut down. To prevent this from happening, check potential blockage areas after heavy use or if you detect a loss of suction or poor cleaning performance.

1DUST CUP

Dust Cup may be full. Empty Dust Cup.

2FILTERS (PRE-MOTOR AND POST MOTOR)

Ensure that both the Pre Motor Filters and the Post Motor HEPA filter are clean.

3ACCESSORIES

Check intake openings:

•Power Brush

•Crevice Tool

•Upholstery Brush

•Dusting Brush

•Flexible Hose

•Floor Kit Handle

•Straight Suction Nozzle

NP320series_40_IB_ENG_120409_2.indd 11

Fig. 16

CLEANING THE POWER BRUSH

•Turn the Power Brush over, slide the locking latch forward and tilt the cover upward to remove. (fig. 15)

•Inspect the rotating bristle brush, turbine wheel and air passage.

•Remove any blockage or debris and carefully, without damaging the bristles or belt, cut any build-up of hair or string wrapped around the rotating bristle brush with scissors.

•To reassemble, first insert the tabs on the front edge of the cover into the matching holes in the top half of the Power Brush and tilt the cover back down pressing until it clicks into place. (fig. 16)

12-04-09 2:08 PM